|
|
#1
Thu 17 December 2009, 20:49
|
|||
|
|||
Hello from Palm Springs
I just learned about CNC and I am very interested in building a Mechmate. I am going over to read the construction docs. I am also going to look up software any suggestions in the software department? From the pictures the Mechmate looks pretty sturdy.
Cheers Christian 
|
|
#2
Fri 18 December 2009, 05:55
|
|||
|
|||
|
Welcome Christian,
It's a little intimidating at first. One of the best "get acquainted" techniques is to read through several of the "personal build threads" found in MechMates Already Cutting. Best of luck.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Weight balancing springs - Gaslifts and coiled wire | Gerald D | 40. Z-Slide | 54 | Sun 30 August 2015 04:31 |
| M310100K Springs for loading motors against the racks | Gerald_D | Motors & their mountings | 11 | Tue 10 June 2014 04:08 |
| Long Z axis and motor springs | glintid | 40. Z-Slide | 5 | Thu 16 January 2014 09:32 |
| Multiple gas springs for extended stroke | sprayhead | 40. Z-Slide | 12 | Fri 12 December 2008 07:26 |
