|
|
#1
Fri 04 September 2009, 03:28
|
|||
|
|||
|
A quick job for one of my suppliers (My first export order...
 )Attachment 5950 Base is of African Mahogany (I think  )Attachment 5951 Attachment 5952 3D engraved text Attachment 5953 close up of the text - still with direct drive motors 
|
|
#2
Fri 04 September 2009, 03:39
|
|||
|
|||
|
I see you also went and visited PTR in Woodstock.Better watch Kobus don`t like it when we do small cutting.What was your feeding speed?
|
|
#3
Fri 04 September 2009, 05:18
|
|||
|
|||
|
Actually I used a ProTech 30deg V groove I picked up at Hardware Centre CT. Feed speed was 1000mm/min, time to machine about 8 min. I also machined the bevel base with the MechMate. Clamped the block upside down at an angle and ran the head up and down across the block feeding Z down a little bit at a time manually - like one would do on a milling machine, writing the code would have taken me longer
 .
|
|
#4
Fri 04 September 2009, 12:26
|
|||
|
|||
|
Hey you guys, what about RETURN on INVESTMENT...you are not suppose to have FUN
Pragtig
|
|
#5
Fri 04 September 2009, 17:12
|
|||
|
|||
|
Beautiful work Alan.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Communion cup holders from hardwood | J.R. Hatcher | The Show Room | 18 | Tue 10 March 2009 11:59 |
| Electronics Text Books Online | Bumole | Golden Resources | 1 | Thu 08 May 2008 05:22 |
| Engraving text - single line fonts vs. 3D carved | Marc Shlaes | General - MM Operating | 3 | Tue 19 February 2008 07:03 |
| Small problems | Admin | Test Area for this forum | 14 | Sat 02 June 2007 23:41 |
