|
|
#1
Thu 27 September 2012, 10:39
|
|||
|
|||
|
configurable limit switch. for multiple uses.
iam asembling the machine. looking for ways to put the primity swich. and i realise. what if i dont want the gantry go to some places of the table in case of errors.
example. if you set a removable plasma bed over the spoil board you can move your limits to avoid the plasma torch go where the spoil board is.  i have to test it but it works on my mind.  
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VFD Control Switch Question | MAC2009 | 70. Control Systems | 6 | Tue 27 September 2011 05:39 |
| Multiple routers/spindles/drills? | robertmonroe | 50. Toolheads | 4 | Fri 02 April 2010 22:38 |
| Bearing Skates for multiple uses. | ddoggett | The Market Place | 22 | Thu 04 March 2010 17:13 |
| Isolator switch ? | andyclarkecncuk | 70. Control Systems | 12 | Wed 24 June 2009 11:46 |
| Multiple gas springs for extended stroke | sprayhead | 40. Z-Slide | 12 | Fri 12 December 2008 07:26 |
