|
|
#1
Sat 12 December 2009, 14:13
|
|||
|
|||
|
Advice on Proximity Sensors
After reading all I can find on proximity sensors I have just one question: which one? Any advice on the correct model from the Factorymation catalog? NPN vs PNP? sensing distance? (I assume 4mm?) Thanks
|
|
#2
Sat 12 December 2009, 15:29
|
|||
|
|||
|
Hi Joe,
You must of pass through this one. All info you’re looking for, right here. If more question, simply come again  Amicalement, Robert 
|
|
#3
Sat 12 December 2009, 17:11
|
|||
|
|||
|
Robert: Thanks, that is just right. Don't know how I missed it even after searching on "Factorymation."
You must have these threads memorized  Joe
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Limit Switches - optical / mechanical / proximity | Gerald_D | 70. Control Systems | 333 | Sun 24 January 2016 15:32 |
| Mounting hole for proximity switch - mod to spider? | dmoore | 40. Z-Slide | 19 | Mon 20 June 2011 23:25 |
| Advice on Wantai Motors | jehayes | Motors & their mountings | 6 | Wed 20 January 2010 04:41 |
| Desperately in need of sound advice. | spider56 | Archives | 6 | Fri 01 February 2008 13:53 |
| Stepper Advice | Bumole | Motors & their mountings | 2 | Fri 14 December 2007 00:27 |
