MechMate CNC Router Forum - Advice on Proximity Sensors

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)

- 70. Control Systems (http://www.mechmate.com/forums/forumdisplay.php?f=28)

- - Advice on Proximity Sensors (http://www.mechmate.com/forums/showthread.php?t=2354)

jehayes

Sat 12 December 2009 14:13

Advice on Proximity Sensors

After reading all I can find on proximity sensors I have just one question: which one? Any advice on the correct model from the Factorymation catalog? NPN vs PNP? sensing distance? (I assume 4mm?) Thanks

Robert M

Sat 12 December 2009 15:29

Hi Joe,
You must of pass through this one. All info you’re looking for, right here.
If more question, simply come again :D
Amicalement, Robert ;)

jehayes

Sat 12 December 2009 17:11

Robert: Thanks, that is just right. Don't know how I missed it even after searching on "Factorymation."

You must have these threads memorized:)

Joe

All times are GMT -6. The time now is 15:20.