MechMate CNC Router Forum
>
After Building the Beast - Operating , Troubleshooting and Maintenance
>
Cutting various materials - bit selection, feeds, speeds
> The skinny end on Mills
PDA
View Full Version :
The skinny end on Mills
Fox
Wed 10 September 2014, 15:50
Beginners explanation on mill bits (http://makezine.com/magazine/make-40/endmills/)
Drexel
Thu 11 September 2014, 04:52
Thanks Fox. That's the kind of info that will save this beginner a lot of frustration and money.
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.