View Full Version : Motiontek, Canada
djharris
Wed 10 February 2010, 20:11
Has anyone purchased from Motiontek in Canada? (www.motiontek.ca) They offer both servo and stepper motor kits, which is better value?
Dave
domino11
Wed 10 February 2010, 21:17
Dave the Mechmate uses stepper motors. I do not think anyone has adapted servo motors to the MM chassis. You can also order Oriental Motor steppers through TRI-R Power Products supplies Oriental Motor worldwide from Canada (http://www.mechmate.com/forums/showthread.php?t=2022)
riesvantwisk
Thu 11 February 2010, 06:40
Dave,
Maris from geckdrive gave some solid advice on servo vs stepper, the short answer is that for our application and size of machine we should use steppers.
I didn't buy from motiontec.ca though, but I am sure if you buy steppers within the needed spec for the MM you will be fine. if you are not up to the electronics and finding it out, I would advice to use a proved combination of PMDX, Gecko and oriental/motionking steppers.
Ries
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.