|
|
#1
Thu 22 September 2011, 04:21
|
|||
|
|||
|
Anyone can help for moter turning setup
I have not understand how to setup motor turning X Y Z for Mach 3
Anyone can help ? Thanks  
|
|
#2
Thu 22 September 2011, 06:47
|
|||
|
|||
|
Have you looked at the videos at the Mach website?
|
|
#3
Sat 08 October 2011, 21:19
|
|||
|
|||
|
There is a basic video, I have followed it perfectly. I have no movement and mach3 isnt running code for me.
Jas
|
|
#4
Sat 08 October 2011, 21:52
|
|||
|
|||
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motors turning! (under EMC) - Perth, Western Australia | shaper | Construction started, but not cutting yet | 25 | Thu 14 November 2024 04:30 |
| Another workholding setup | lumberjack_jeff | General - MM Operating | 15 | Tue 29 September 2020 02:31 |
| mach 3 setup help | paul60 | 70. Control Systems | 7 | Tue 03 August 2010 11:02 |
| The setup of 2 motors on 1 axis | cnc'tje | 60. Wiring & Cable Management | 2 | Sun 07 March 2010 10:38 |
| Newbie has motors turning already - Alpharetta GA | reza forushani | Construction started, but not cutting yet | 33 | Fri 25 May 2007 21:46 |
