|
|
#1
Sun 09 August 2009, 11:55
|
|||
|
|||
|
First Commercial Order
I have been off the MM forum for quite a some time. I had my first order today for 3 Mirror frames cut from 4' x 2' MDF 16 mm thick. I was fun doing today after a faulty wire stopped my machine for over 2 hours in between. The total design was V carved with 90 deg V tool at 70 IPM feed rate.
I will be cutting the Mechmate Name plate on Wood tommorow to grab the Sl.# 30 .. hope its available. But man working with Artcam is really like starting from Kindergarden to Phd  looks like my brain has be sharped. Mechmate is Neighbours envy and a owners pride.  
|
|
#2
Sun 09 August 2009, 12:00
|
|||
|
|||
|
good work vish
|
|
#3
Sun 09 August 2009, 12:16
|
|||
|
|||
|
Good to see you again Vishnu!
|
|
#4
Sun 09 August 2009, 17:04
|
|||
|
|||
|
Vishnu,
Looks good.
|
|
#5
Sun 09 August 2009, 19:01
|
|||
|
|||
|
Vishnu,
Very nice frames.
|
|
#6
Sun 09 August 2009, 23:06
|
|||
|
|||
|
Nice Vishnu!
|
|
#7
Thu 13 August 2009, 09:42
|
|||
|
|||
|
Beautiful work Vishnu.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mirror frame | javeria | The Show Room | 12 | Fri 14 December 2012 17:10 |
| Cutting mirror frames - Coimbatore,India | vishnu | MechMates already cutting | 95 | Mon 17 August 2009 08:31 |
| Customer wanting someone to build a MechMate to spec | dneisler | Archives | 43 | Tue 05 August 2008 15:48 |
| Using the Oriental Motor Alpha-Step motors on the MechMate frames. | Gerald D | Archives | 1 | Sat 29 September 2007 11:43 |
