|
|
#1
Wed 06 May 2009, 01:03
|
|||
|
|||
|
slow motion like animation
 I just put a rhyming word out there  well here is the problem I have set steps per millimeter as 79.577 and the motors are driving crazily slow ! now if i set it to something like 250 steps per mm. which id offcourse wrong then its crazily fast. I know it should have been otherwise ?  i don't even know what I am missing :??????? also the whole machine racks and jerks - may be bcos I have not yet tightened all the bolts - but that can be chkd later - hope some one can suggest what I am missing  RGDS IRfan |
|
#2
Wed 06 May 2009, 01:08
|
|||
|
|||
|
Have you switched Mach from its default "inches" over to "mm"?
What is your belt ratio, pinion tooth count, and rack module/DP? |
|
#3
Wed 06 May 2009, 01:09
|
|||
|
|||
|
Config -> Select Native Units -> check MM
|
|
#4
Wed 06 May 2009, 03:09
|
|||
|
|||
|
Yes G' thats the exact thing I thought about - but I was in office since
will get back on this tomorrow morning : thank you - RGDS IRfan |
 |
|
|
