Considering a build - Utah
 

Karl here.
Looking things over before starting a build.
I am in Utah USA.
Accomplished at woodworking and proficient at stick welding.
I am currently building a JGRO MDF router table and ran across this site in my reasearch.
This will be my second table after I get good at welding with MIG.

Karl,

Welcome and good luck with your build.

Welcome Karl,

Hi Karl....

MIG is pretty easy once you get the hang of it... Keep your metal clean, set the current and feed rate right, keep your ground close to the welds and you'll be proficient in a hurry...

Hi Karl,
Welcome. You don't need to be good at welding to build MM... & you don't even need MIG welder...

PS, if you need an excuse to delay the build, 1) reading & studying the plans 2) collecting parts are more acceptable excuses :)

Karl: Welcome to the asylum (where the inmates run the show.)

Building the MM is more fun than anyone has a right to while still in the vertical plane!

Joe

Joe, you mean I can't leave? :eek:

welcome Karl.. that was my experience too. came across the site while building my first machine. But as you will soon see, it will be good experience for when you begin your MechMate!