what a MM can do -
 

Hi Folks - this is what we recently did on our mechmate
http://www.youtube.com/watch?v=DBf5Sco6SmM

Fantastic!

Beautiful Artwork

Now this is what I like. Well done Irfan

Very good carving ! what kind of wood is it ? can you post picture once you got the finish on . thank

That is nice!

Thats teak wood slab of 2x3 ft, cost 200USD eq, rough finish took 2hrs, relief took 6 and v bit carving took 4 hrs, started 6 am finished noext morning 1 am.

roughing - 8mm router bit
relief - 3mm ball nose
v bit - 20 degree 3mm dia v bit

Irfan, didn't anybody tell you that you cannot do a job like that with open loop steppers? Were you not supposed to be using servos? How did you fix the marks caused by the lost steps? ;);)

Irfan, Very well done!

Nice
 

Top notch work!

Great work. Irfan. Well done.

:eek:

Irfan, my next tour is to Bangalore :D

awesome! what software did you used?

Irfan that looks fantastic.

Did you do the 3D model yourself or someone else?

Look forward to pics of it finished.

Greg

Ah - yes the work is fantastic - but I have just used the relief and changed a couple of tools and waited it out :)

The true credit goes to my Artcam guru for the relief and Mechmate (our beloved G') for executing it out.

RGDS
Irfan

Does your Artcam guru sell these type of files. I am sure there are a few of us that would like to buy these types of files. Let me know please.

me too....me too...:)

Beautiful carvings. ...