MechMate CNC Router Forum - Spindle Collet

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)

- 701. Motor Drives (http://www.mechmate.com/forums/forumdisplay.php?f=14)

- - Spindle Collet (http://www.mechmate.com/forums/showthread.php?t=1457)

rocky2889

Fri 27 February 2009 13:14

Spindle Collet

I brought an used spindle "Elte TMPE3 12/2". I like to find out the size of the collet.
The only information engraved on the collet nut is "Schaublin EXE25 61-25720" I didn't see the ER25.

Do you is ER25 will fit that drive?

Thanks

Rocky

Gerald D

Fri 27 February 2009 13:23

It's bedtime here, but you can find some dope in:
http://www.schaublin.ch/catalogues/PI41-47.pdf

Havn't got time to check what matches the M32x1.5 thread of your nut

Gerald D

Sat 28 February 2009 11:09

The M32x1.5 thread is typical for ER25.

rocky2889

Sat 28 February 2009 14:45

Thank you, you are the BEST.

All times are GMT -6. The time now is 02:20.