| Author |
Message |
    
fabrica
Registered
Username: Daya
Post Number: 247
Registered: 10-2006
| | Posted on Tuesday, January 30, 2007 - 05:46 am: | 
|
Gerald, I have fixed the home switches on X and Y axis. But when the gantry and Y car hits these points I cannot get it to move forward to disengage the switches. I have gone trough the Mach 3 manual to find a solution for this but so far has not been able to sort out the issue. |
Gerald_D
Registered
Username: Gerald_d
Post Number: 788
Registered: 11-2005
| | Posted on Tuesday, January 30, 2007 - 07:33 am: |
|
Remember that setting that was giving you troubles when 2 axes were running? Alt6 > overide limits? I think that is where you go when you temporarily want to run away from a limit. (I don't have switches, so I am not sure)
However, in reality your router should never get to the switches if you have set the "Soft Limits" with the basic table size info. (We don't use this either) |
Greg Holt
Registered
Username: Greolt
Post Number: 16
Registered: 08-2006
| | Posted on Tuesday, January 30, 2007 - 02:25 pm: |
|
You have fitted homing switches, make sure you have not set them in "ports and pins" as limit switches.
Mach treats homing and limits quite differently. |
fabrica
Registered
Username: Daya
Post Number: 248
Registered: 10-2006
| | Posted on Tuesday, January 30, 2007 - 06:37 pm: |
|
Thanks Greg, I will check on this tomorrow and give you a feedback. |
Gerald_D
Registered
Username: Gerald_d
Post Number: 798
Registered: 11-2005
| | Posted on Tuesday, January 30, 2007 - 08:38 pm: |
|
Also keep an eye here:
http://groups.yahoo.com/group/mach1mach2cnc/message/68390 |
70. Control Systems