|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Mon 12 September 2011, 07:48
|
|||
|
|||
|
5 phase stepper motor.
Hi, does gecko controller support 5 phase stepper motor?
|
|
#2
Mon 12 September 2011, 12:35
|
|||
|
|||
|
Look at their website
http://www.geckodrive.com , but for a multiphase (more than two) you need a different driver than gecko I think. They are only 2 phase bipolar drives.
|
|
#3
Mon 12 September 2011, 13:36
|
|||
|
|||
|
I think you will find it hard to get a good affordable driver for 5 phase motors. There was some discussion on this forum about that a few times. The recomendations were to get some good motors that work well with the gecko drivers. See the motor selection thread for starters.
|
|
#4
Mon 12 September 2011, 17:58
|
|||
|
|||
|
Quote:
If you plan to use these motors, you should consider the cost of it drivers, my intuition says a bipolar motor + driver will cost you less than a 5 phase drive for them. Pablo
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 phase vs single phase VFD's - is there a loss in one vs the other? | chopper | 50. Toolheads | 16 | Mon 08 April 2013 03:38 |
| UIROBOT Stepper Drives | uirobot | The Market Place | 76 | Tue 31 January 2012 10:45 |
| True Torque of a Servo motor for comparison to a Stepper motor, when used in a router | Mcyoda | Motors & their mountings | 3 | Tue 19 August 2008 01:50 |
| What does a stepper motor look like inside? (geared Oriental Motor) | Gerald D | Motors & their mountings | 0 | Sat 16 August 2008 09:29 |
| Unknown stepper motor | Glenn D | Archives | 5 | Sat 09 August 2008 19:33 |
