|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Spur Gear decision
Hi, I have 640oz (+,-) with a 4:1 gear ration on top of that.
Going to purchace the stdsteel gear rack 20/20 (or w.e it is i dont have the info right in front of me. But i was wondering which spur gear should i go for A 20 or 24 tooth gear. there is also a 32 tooth but i would rather smoother then faster. What do you all suggest? |
#2
|
|||
|
|||
For smoother, rather than faster, the 20 tooth would be the choice in the inch based diametral pitch system (DP 20).
|
#3
|
|||
|
|||
Thank you Gerald you are fast at replying and always a help. I also had a question. Is there a formula to estimate accuracy? I saw the resolution but thats not necessarily accuracy or is it?
|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moore Gear Racks | jessyjames | The Market Place | 2 | Mon 15 March 2010 22:32 |
Pinion gear chatter | lunaj76 | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 5 | Tue 27 October 2009 01:29 |
Inconsistent accuracy - loose pinion gear | bfauska | Troubleshooting | 11 | Sat 05 September 2009 09:05 |
Z axis gear reduction | Art | 40. Z-Slide | 0 | Mon 10 March 2008 19:01 |
Why must the gear teeth be so small or fine? | driller | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 15 | Wed 27 February 2008 21:56 |