#1
|
|||
|
|||
vacuum table question
I always hate to ask questions that may have already been answered else where but i have searched and can't find my answer. So, please forgive me if i am asking "a same ole question".... I understand pretty much about vacuum tables except this>> Am i to understand that you can pull air, i.e., a vacuum THROUGH a piece of mdf board which i guess is also your spoil board?? Thanks
|
#2
|
|||
|
|||
Tom,
No worries...Yes you can pull a vacuum THROUGH certain materials. Certain densities of MDF work better than others, but most variants of MDF are porous. There are many instances of this being used in CNC work in general. The forum has a few examples of a "waffle grid" and "sealed edge" MDF spoilboards for this purpose. Pending your application, you may need to choose a particular style of holddown that suites your needs. Feel free to poll the forum....we're nice here! Sean |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to use Ubuntu - Klang Malaysia | KenC | MechMates already cutting | 457 | Mon 05 March 2012 04:57 |
Commercial Vacuum kit | silverdog | The Market Place | 15 | Sun 06 March 2011 10:03 |
Can I use this for vacuum pump? | 15mgtar | 55. Dust Management | 7 | Fri 26 March 2010 10:48 |
Vacuum Crane | sailfl | Miscellaneous / General / Whatever / Catchall | 0 | Fri 13 February 2009 20:12 |
General Table Question | Greg J | 10. Base Table | 29 | Tue 16 December 2008 07:35 |