|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Thu 08 July 2021, 09:31
|
|||
|
|||
|
how to slave x motors
I have a shobot prt 96.
when i tried to run this morning it jump the rail found out x motors moving in the same direction. need advise in resetting the slave . is there a step by step instructions anywhere ? If anyone can help thanks paul 
|
|
#2
Fri 09 July 2021, 17:04
|
|||
|
|||
|
I believe Shopbot use their own software. Mechhmates typically use LinuxCNC or Mach.
I'm sure the guys over at http://www.talkshopbot.com/forum/forum.php will be able to help you.
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach3 X axis with 2 motors set as slave | viz | 70. Control Systems | 7 | Sat 08 September 2012 09:58 |
| Stepper motors giving trouble - Motors burnt while serving as ground for elec. fault | Daya | Troubleshooting | 45 | Mon 21 April 2008 02:05 |
