|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Mon 06 May 2019, 21:11
|
|||
|
|||
|
motor tuning g-force in Mach preferred settings
In the motor tuning section of Mach3/4 what is the preferred setting for g-force given the weight of a typical mechmate build?
|
|
#2
Thu 30 May 2019, 07:03
|
|||
|
|||
|
Mine is set at .081503. The software determined that for me. I could not find a preferred setting, based on weight. I suspect that it would also depend on the motor setup, you have configured. I use a (slow) cutting straight drive setup.
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stepper Motor tuning Help, Please | Jonazizbey | MechMates already cutting | 29 | Sun 21 August 2016 06:07 |
| Typical settings for Mach motor tuning | Kobus_Joubert | CNC motion control software | 19 | Sun 15 May 2016 10:04 |
| Need help with jog speed in Mach3 motor tuning !!! | rival | Troubleshooting | 45 | Sat 03 September 2011 05:03 |
| Mach 3 CV settings | Greg J | General - MM Operating | 2 | Wed 17 November 2010 14:49 |
| Gecko / Motor Tuning | sailfl | 701. Motor Drives | 9 | Tue 06 April 2010 12:13 |
