|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Tue 19 June 2012, 15:28
|
|||
|
|||
|
Hi From North Florida and NEED Help :) Will Pay :)
I was referred here form the Sawmill Creek forum (been a member there for years.....)
Looking for someone that KNOWS how to troubleshoot and configure a CNC Plasma Cutter. This machine uses Mach 3,Gekko Drivers G201's and CNCzone torch height controller and boards. My buddy bought this used and we can't get the motors to even turn.....willing to pay a fare rate for results. Would even entertain travel expenses to the right person. The unit is located in the Pensacola,Florida area. If you know what you are doing and also live around here this offer could extend and allow you use on the machine as well! We're not dummies...I hava a cnc laser cutter, so I know the fundamentals, just need someone focused on the goal! Thanks! Jack 
|
|
#2
Thu 21 June 2012, 13:19
|
|||
|
|||
|
Try asking over at: plasmaspider dot com
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Starting To Weld, Riverview, Florida | Mrayhursh | Introduce yourself and start planning | 8 | Sun 01 April 2012 23:32 |
| Joining you from Florida Learning to build - Mia, FL | Ruffs700 | Introduce yourself and start planning | 7 | Wed 20 July 2011 20:42 |
| Plasma in Florida | Jimmystractor | Introduce yourself and start planning | 16 | Fri 18 March 2011 23:54 |
| Hello from Florida | Jamuto | Introduce yourself and start planning | 4 | Sun 06 February 2011 06:57 |
| New from Florida | traviswaite | Introduce yourself and start planning | 4 | Thu 03 December 2009 17:37 |
