|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Sun 22 September 2019, 20:10
|
|||
|
|||
|
Latte Panda driver
I was talking with my I.T. friend yesterday about Latte Panda.
https://www.lattepanda.com/ It should be possible to use one of these to run my MechMate. http://www.lattepanda.com/products/3.html Any comments or suggestions welcome. It is about time to move away from old computers and parallel ports. 
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 110 volt stepper driver...no need for PS? | IMMark | 701. Motor Drives | 4 | Tue 19 February 2013 23:39 |
| UIM 240xx step driver help. | window_s | CNC motion control software | 13 | Mon 01 August 2011 05:17 |
| Planning for stepper driver | same79 | Archives | 2 | Wed 01 December 2010 15:40 |
| digital stepping driver | KenC | 701. Motor Drives | 7 | Sun 20 June 2010 10:20 |
