|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Wed 09 October 2013, 19:53
|
|||
|
|||
Trash Bag Holder Design
My OldTimers is getting to have a serious CRS (Can't Remember Squat) component recently.
I remember seeing a nice design for a trash bag holder. Does someone know where it might have been seen? I remember it was made out of some 'scrap plywood' and was a nice flowing design. Any help is appreciated. 
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tape Holder from waste area's. | Regnar | The Show Room | 9 | Sat 01 October 2011 21:48 |
| HTS Rapid Tool Changer + 4 Er-16 Tool Holder + 5 Er-16 Collet | bbreaker | The Market Place | 6 | Tue 01 December 2009 00:14 |
| Dremel holder | normand blais | 50. Toolheads | 0 | Sun 06 July 2008 05:24 |
| A door design | fabrica | The Show Room | 2 | Tue 01 May 2007 12:37 |
| Z-axis design | Dick van Randen | Archives | 4 | Sun 03 September 2006 13:35 |
