#1
|
|||
|
|||
hi,newbie in cnc machine
hi all ,
I am Azzeddine from Morroco . mechmate for me is a big challenge because firstly I'm new to cnc machine the road is long and hard to realize this project Secondly it is dificult to find the right materials in my country and English is not my first language. so I'll do my best with the help of my friends and the great help of this very good forum. there frankly thousands of very useful information I want to use this machine for cutting wood and making decorations something like this in the picture http://71.img-ma.avito.st/640x480/2148871.jpg working area: 2500mm x 1500mm I would start with the construction of the table a little easier until the X-Rail the problems starts I'll take my time to read and of course I'll come back with questions if you want. |
#2
|
|||
|
|||
Welcome, zizou!!
|
#3
|
|||
|
|||
Welcome mate
The road is long for me too but I figure it'll be well worth the effort Cheers Bazza |
#4
|
|||
|
|||
thank you very much mates for your support
|
#5
|
|||
|
|||
Welcome Zizou.
It can be a long road but what a journey. I too found it difficult to find some materials but the design is quite flexible. Good luck to you. |
#6
|
|||
|
|||
Zizou, I just completed my machine and it too had taken a long time. I first downloaded the plans in April 2009 and finally got started in Feb 2013. So just making the decision to commit to it is a big step and at time can be difficult but just keep working at it bit by bit and eventually you'll have something to be proud of. Welcome.
|
#7
|
|||
|
|||
Welcome aboard !!!
|
#8
|
|||
|
|||
Welcome Zizou.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help for a Newbie | Jbozaf | Introduce yourself and start planning | 4 | Wed 04 December 2013 07:05 |
Hi there, absolute newbie here | Change | Introduce yourself and start planning | 6 | Tue 11 June 2013 15:17 |
newbie needs help | GC3 | Introduce yourself and start planning | 1 | Mon 22 November 2010 23:27 |
Newbie | malgazz | General - MM Build | 2 | Thu 11 June 2009 12:37 |
Newbie to Mechmate | area51 | Archives | 1 | Sun 25 November 2007 15:56 |