![]() |
#1
|
|||
|
|||
5 phase stepper motor.
Hi, does gecko controller support 5 phase stepper motor?
|
#2
|
|||
|
|||
Look at their website
http://www.geckodrive.com , but for a multiphase (more than two) you need a different driver than gecko I think. They are only 2 phase bipolar drives. |
#3
|
|||
|
|||
I think you will find it hard to get a good affordable driver for 5 phase motors. There was some discussion on this forum about that a few times. The recomendations were to get some good motors that work well with the gecko drivers. See the motor selection thread for starters.
|
#4
|
|||
|
|||
it doesn't
If you plan to use these motors, you should consider the cost of it drivers, my intuition says a bipolar motor + driver will cost you less than a 5 phase drive for them. Pablo |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
3 phase vs single phase VFD's - is there a loss in one vs the other? | chopper | 50. Toolheads | 16 | Mon 08 April 2013 02:38 |
UIROBOT Stepper Drives | uirobot | The Market Place | 76 | Tue 31 January 2012 09:45 |
True Torque of a Servo motor for comparison to a Stepper motor, when used in a router | Mcyoda | Motors & their mountings | 3 | Tue 19 August 2008 00:50 |
What does a stepper motor look like inside? (geared Oriental Motor) | Gerald D | Motors & their mountings | 0 | Sat 16 August 2008 08:29 |
Unknown stepper motor | Glenn D | Archives | 5 | Sat 09 August 2008 18:33 |