#31
|
|||
|
|||
Drawing 10 10 300
I hope I have not screwed up too badly. I am able to get my rails parallel to each other however my "M" dimension is out at one corner by 3 to 4 mm. I believe that I messed up on one of the lower cross braces length.
Is this a serious issue? Thanks for any input Greg |
#32
|
|||
|
|||
If you are using 1/2" wide rack, a variation of 3-4mm in M should be no problem. Do you have a minimum M of more than 1/2" all over?
|
#33
|
|||
|
|||
Gerald;
Yes I do have enough room all around for the rack. I was hoping that that would be the response. Thank-you very much. Greg |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Staring to plan my first build | erich | Introduce yourself and start planning | 3 | Fri 30 April 2010 06:10 |
Plan Question | Tim655 | General - MM Build | 20 | Thu 25 March 2010 07:18 |
Base table, gantry from working mechmate for sale. | linus1 | The Market Place | 1 | Fri 19 June 2009 04:35 |
Drawing Plan files for downloading - this is where you get the drawings | Admin | Downloads | 0 | Sun 20 May 2007 01:26 |
Drawing Plan files for downloading | Admin | Archives | 0 | Sun 20 May 2007 01:26 |