![]() |
#31
|
|||
|
|||
I installed the Modbus solution recommended by Danilo. I must say that it is a superior controller of the spindle than using the PWM method. No variances is speed and I have not had to use any special 'noise' suppression add-ons. It's a great plugin for the Huanyang VFD. I made sure that I used the RS485 converter that has the Prolific chip (PL2303). The other converter uses a CH341 chip. I ordered one of those also, to try out. It has not arrived yet.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Typical settings for Mach motor tuning | Kobus_Joubert | CNC motion control software | 19 | Sun 15 May 2016 10:04 |
Need help with jog speed in Mach3 motor tuning !!! | rival | Troubleshooting | 45 | Sat 03 September 2011 05:03 |
Gecko / Motor Tuning | sailfl | 701. Motor Drives | 9 | Tue 06 April 2010 12:13 |
Water Cooled Spindle Connections - Connecting the Spindle | waynec | 50. Toolheads | 32 | Fri 19 June 2009 12:31 |
Machine locks up while travelling at high speed - Tuning the motor speeds and accels | Doug_Ford | Troubleshooting | 3 | Sun 03 February 2008 21:55 |