MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Electrical & Electronic > 701. Motor Drives
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Mon 21 January 2019, 16:52
Diplocaulus
Just call me: Gary
 
Kearney
United States of America
Huanyang bit the dust, replaced with Lenze, question about parameters...

Hello, a transformer in the Huanyang blew, so we decided to go with an actual warrantied Lenze VFD from Precision Electric. I added 2 inline fuses to the VFD, wiring is basically ready to go on the mains side, but I have two questions; How do I know which motor connector goes where, the manual doesn't label individual wires apart from ground. It shows "Motor 3~" and just leads them to the motor inputs. I sort of take this to mean it's unimportant which goes where but this seems unlikely. I can talk to them about that on the phone tomorrow, so more importantly how do I know which parameters to set to make mach3 play nice with the vfd? This vfd has 300 parameters and I know I don't need all of them, I tried to correspond them to the set parameters for the Huanyang but they are juuuust different enough to confuse me on some of them. Is this something I figure out on the VFD side or should I be looking more at mach3 to figure it out?
Reply With Quote
  #2  
Old Mon 28 January 2019, 14:18
danilom
Just call me: Danilo #64
 
Novi Sad
Serbia
Its not important UVW, after first motor start , check the CW direction , if its not correct swap one pair of wires that go to the spindle

How did you control the Huanyang, with plugin or 0-10V and FWD command with relay output?
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Setting up a Huanyang HY02D223B VFD Jayson 701. Motor Drives 20 Fri 02 November 2018 07:25
Mach3 plugin for Huanyang VFD racedirector 50. Toolheads 1 Tue 08 July 2014 04:59
Sold...(replaced by heavy Thermwood) #88 - Alberta CAN John Saunders MechMates already cutting 19 Mon 19 November 2012 07:14
HuanYang VFD, A.K.A. The Cheap Chinese VFD KenC 50. Toolheads 37 Thu 26 August 2010 13:10
Dust-proofing stepper motors and consequences of dust ingress Doug_Ford Motors & their mountings 25 Thu 08 November 2007 19:09


All times are GMT -6. The time now is 22:12.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.