|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Corner finder
Made a couple more tools for my MechMate today.
This is a corner finder, it can also be used to set z-hieght. I saw one of these on CNC Zone....thought it was pretty neat so I made one. To use this tool, place it on the corner of your material and center the cutting bit over the copper pipe. Lower the bit so it is just inside the pipe and run the centering script. Note, the bit does not have to be exactly in the center of the pipe just close. The script will determine the exact center for you and set the Mach3 dro's |
#2
|
|||
|
|||
Here is the link to the CNC Zone for anybody that needs it
http://www.cnczone.com/forums/mach_w...ification.html Regards Skippy Last edited by skippy; Tue 23 November 2010 at 19:15.. Reason: add more detail |
#3
|
|||
|
|||
I know that much has been said about zeroing routines but this is just another gadget that is available. Similar to the one shown in the previous post.
http://www.themakersguide.com/home/p...-edge-finder-2 You can see it in operation here. http://www.themakersguide.com/home/t...ntent-module-3 Clayton Last edited by cleyte; Tue 28 May 2013 at 10:26.. Reason: correction |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|