|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Sat 20 October 2012, 06:08
|
|||
|
|||
Good morning all !!
Hi from Michigan, just found this site and I am excited! I see plans are 100.00 does anybody have a finished cost total?
|
|
#2
Sat 20 October 2012, 06:43
|
|||
|
|||
|
The MechMate averages between 5k and 7K depending on how you source parts.
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Searching a good TAP WRENCH | isladelobos | Miscellaneous / General / Whatever / Catchall | 7 | Wed 08 June 2011 13:02 |
| Had a good day on the girl today! #45 - Melbourne, Aus | rnixon | MechMates already cutting | 63 | Mon 16 May 2011 15:54 |
| MechMateWiki.com - free to a good home | Delamination | Miscellaneous / General / Whatever / Catchall | 1 | Sun 19 September 2010 08:49 |
