#1
|
|||
|
|||
position error for cable chains
as wrong, I did not weld the end of the gantry properly.
The one planned for the passage of the cables is on the wrong side (in front of the gantry) as we can see on the first picture, I will have to reverse the parts that support the cable chain of the gantry. I understand that I will have the engine behind. Can I have other problems than the media to modify? je me suis trompé ,je n' ai pas soudé l' embout du portique correctement. Celui prévu pour le passage des cables est du mauvais coté(devant le portique) comme on peux voir sur la premiére photo ,je vais devoir inverser les pieces qui supporte la chaine de cable du portique. J' ai bien compris que je vais avoir du coup le moteur derriére. est ce que je risque d' avoir d' autres probléme que les supports a modifier? |
#2
|
|||
|
|||
I made same mistake when was building #38. Put that cable carrier to other side of gantry.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Incrementing error in cutting?? | giggler | Troubleshooting | 7 | Tue 13 September 2011 07:29 |
Spiderplate error (booboo when drilling) | oddname | 40. Z-Slide | 14 | Thu 04 March 2010 13:29 |
Can backlash give a cumulative error? | Gerald D | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 43 | Sun 31 January 2010 12:08 |
Re-alignment after dis-assembly - getting all parts into position at the new location | kanankeban | 10. Base Table | 11 | Sun 25 January 2009 11:48 |
10 20 235 Y-Rail Clamp Strip - getting it into position . . . . | dmoore | 20. Gantry | 12 | Thu 05 June 2008 08:39 |