|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Spring tension adjustment - is it needed?
Hello people,
I have built a machine very similar in architechture to the Mechmate. A possible suggestion is to bond the racks onto their supports with epoxy. Very quick, it handles the loads with ease, is removable (with judicious use of a heatgun) and no drilling required. Another advantage is that the joining of racks end-to-end becomes very simple. Just bond them in the right position, using a short piece of offcut rack turned upside down and meshed with the two sections being joined to keep the pitch right. The pinion does not even know about the joint. On the subject of backlash between pinion and rack, I use exactly the same principle, only difference is a bottlescrew (turnbuckle) instead of a spring. No problem so far, touch wood. Regards, Dries |
#2
|
|||
|
|||
Quote:
Do you use a turn buckle with a spring like this: Or do you use just a turnbuckle? The advantage on the MechMate with the use of properly tensioned springs is that if you hit a stop, the spring will allow the pinion to ride up and out of the rack - protecting the motor. |
#3
|
|||
|
|||
This is more precise and easy to install, only need a hole in the plate engine
otro facil de construir. |
#4
|
|||
|
|||
Those are nice but I'm still not seeing an advantage over just $10 worth of springs for the entire MechMate. The springs work very well, are inexpensive, allow the pinions to pop out when they hit the stops and don't suffer from vibration and they also maintain zero backlash.
Thanks, david |
#5
|
|||
|
|||
David, I've hit the stops darn hard on my machine but the pinions have never popped out because by that time the steppers have no power, the limit switch has already been tripped.
|
#6
|
|||
|
|||
Quote:
It's a good design feature - much better than when the same thing happens on a screw based design - where either the coupler breaks or the nut strips out, both that require repair. I agree with you - with limit sensors are the way to go, and with soft limits in Mach3, you should never hit anything even on accident. |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|