MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Electrical & Electronic > 702. Power Supplies
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #31  
Old Fri 22 June 2012, 07:55
KenC
Just call me: Ken
 
Klang
Malaysia
Ground loop.
Reply With Quote
  #32  
Old Fri 22 June 2012, 18:53
David Bryant
Just call me: David #99
 
Western Australia
Australia
In Australia we have a connection at the meter box that is the MEN. The Main Earth Neutral Link. This is the only place on a house that the Neutral is connected to the Earth.
If the (AC) neutral is connected to a DC ground, earth of a machine in Australia the Safety switch (Earth leakage breaker, Residual current detector are other names) would switch the power off.
This leads us to use dual pole switching often to isolate the AC line and Neutral. The Earth wire is used to ground the machine.
This has advantages in isolation and allows our machines to have a single earth point to as ken says eliminate earth, ground loops. These are currents that flow in the earth wires if they are joind in loops. (Like a single turn of wire added to the transformer above.)
This makes our eacth wires go out from a single point like a star.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Why not use an adjustable, regulated power supply? Bob Cole 702. Power Supplies 19 Thu 25 August 2011 09:33
Choosing my motors & power supply Rusty Nuts Motors & their mountings 2 Sun 31 July 2011 14:39
Strange movements - bad power supply to BOB tnarch Troubleshooting 26 Fri 25 March 2011 19:37
Need Help with Power Supply Selection F2DVasek 702. Power Supplies 2 Wed 19 May 2010 03:25
The Power Supply needs only to supply 2/3 of the rated motor current Gerald D 702. Power Supplies 0 Sat 05 December 2009 20:09


All times are GMT -6. The time now is 11:19.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.