MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Electrical & Electronic > 702. Power Supplies
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Fri 06 November 2009, 13:22
Mitch_1
Just call me: Mitch
 
Sussex
Canada
Send a message via Skype™ to Mitch_1
Easy Torroidal Transformer

Hello Guys....possibly gals....?

I need a source for a toroidal transformer by any chance has someone salvaged one out of something that is readily available, like possibly a copier or something,

I want to connect it to a PMDX135 either 50V or 80V, which PS would be better for running 4, PK296A2A-SG7.2's and what should the power rating of the toroid be, (max voltage x max current) of the PS? or is that over designing, cause a 1600 watt toroid might be expensive.

This information might already be in a thread somewhere but I only looked for about about an hour and didn't find any concrete answers.

Thanks
Mitch
Reply With Quote
  #2  
Old Fri 06 November 2009, 15:40
MetalHead
Just call me: Mike
 
Columbiana AL
United States of America
https://www.antekinc.com/

Best source for Transformers and power supplies.
Reply With Quote
  #3  
Old Sat 07 November 2009, 05:52
Richards
Just call me: Mike
 
South Jordan, UT
United States of America
I use a 25VAC transformer (~35VDC) when I wire PK296A2A-SGxx motors half-coil. You could go just a little higher (28VAC = ~39VDC) before you have to worry about excess heat. Each motor pulls up to 3A, so 3A X4 = 12A. 12A X 25VAC = 300VA.

I've used both a 250VA and a 500VA transformer with 4 PK296A2A motors. Both sizes worked just fine.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
The second MM was easy, but the building's electrics were noisy #28 - Orlando, FL smreish MechMates already cutting 50 Fri 19 October 2012 09:45
Fire, how easy it is to start one! smreish 55. Dust Management 8 Sun 10 October 2010 20:22
Transformer Selection KenC 702. Power Supplies 2 Tue 21 July 2009 06:14
Timing pulleys made easy stcnc The Market Place 0 Mon 08 September 2008 15:02
Moving from SB to Mach software is it really that easy or good Gerald_D Archives 45 Mon 09 October 2006 21:28


All times are GMT -6. The time now is 04:21.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.