MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Common Assemblies & Parts > Rails & Rollers
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Sat 09 February 2013, 02:18
saas
Just call me: saas
 
ceje
Slovenia
problem assembly rails roller

..my future problems ...




I agree that the forum has all explained ...

but good advice is never excess

tx
Reply With Quote
  #2  
Old Sat 09 February 2013, 22:45
Regnar
Just call me: Russell #69
 
Mobile, Alabama
United States of America
Looks like you need to regrind your rails and this time drill the holes in the right location. All the other work arounds would take longer than regrinding and drilling.
Reply With Quote
  #3  
Old Sat 09 February 2013, 23:00
Surfcnc
Just call me: Ross #74
 
Queensland
Australia
SAAS

You should establish what is wrong.
1. is the table too narrow
2. or is the gantry too wide
3. or are the rails attached incorrectly.

Either way the motor swing plates will need to be in the correct place or the pinion will not engage correctly with the module 1 drive rack that is stuck to the underside of the gantry rails.
What ever fix you use, you will need to consider its impact upon the next step past just fitting the roller into the rail.

Regards
Ross
Reply With Quote
  #4  
Old Sun 10 February 2013, 00:49
Gerald D
Just call me: Gerald (retired)
 
Cape Town
South Africa
Picture 1: Carefully cut end off gantry, shorten tubes, reweld the end
Picture 2: Leave it like that
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Gantry end assembly. Is this correct Red_boards 20. Gantry 9 Sat 05 February 2011 02:21
BOM (Build Of Materials) Grind Head Assembly M6 10 100 AA (Rail Grinding Skate) skippy Rails & Rollers 1 Sun 01 November 2009 06:11
Need opinion on round bar rails with roller Claudiu Rails & Rollers 3 Fri 03 July 2009 13:05
Re-alignment after dis-assembly - getting all parts into position at the new location kanankeban 10. Base Table 11 Sun 25 January 2009 12:48
Upper limit of weight for Gantry and Y-car assembly Sheldon Dingwall 20. Gantry 2 Wed 28 March 2007 08:34


All times are GMT -6. The time now is 18:33.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.