MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Structure & Mechanics > 50. Toolheads
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #31  
Old Wed 13 May 2015, 17:32
timberlinemd
Just call me: Steve #66
 
Arizona
United States of America
I installed the Modbus solution recommended by Danilo. I must say that it is a superior controller of the spindle than using the PWM method. No variances is speed and I have not had to use any special 'noise' suppression add-ons. It's a great plugin for the Huanyang VFD. I made sure that I used the RS485 converter that has the Prolific chip (PL2303). The other converter uses a CH341 chip. I ordered one of those also, to try out. It has not arrived yet.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Typical settings for Mach motor tuning Kobus_Joubert CNC motion control software 19 Sun 15 May 2016 10:04
Need help with jog speed in Mach3 motor tuning !!! rival Troubleshooting 45 Sat 03 September 2011 05:03
Gecko / Motor Tuning sailfl 701. Motor Drives 9 Tue 06 April 2010 12:13
Water Cooled Spindle Connections - Connecting the Spindle waynec 50. Toolheads 32 Fri 19 June 2009 12:31
Machine locks up while travelling at high speed - Tuning the motor speeds and accels Doug_Ford Troubleshooting 3 Sun 03 February 2008 21:55


All times are GMT -6. The time now is 02:44.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.