Spindle Frequency?

[lukebarber]

I bought and installed a new 1.5hp water-cooled spindle with an inverter to run it. Inverter is esv112n02yxb . Now whenever I switch the spindle on, it triggers my limit switches (in Mach3) and I can only reset it when the spindle is not running. Would adding a line reactor to the inverter help? Spindle and limit switch wiring is all shielded and properly grounded.

I'm virtually at a standstill. Any help?

[danilom]

What breakout board are you using ? is it optoisolated?

If it is isolated I would first try to connect the PC to the mains with small line filter.

also check if everything is properly grounded , if the vfd has internal emc filter try disconnecting it , this was known to make me problems with control techniques vdf

[lonestaral]

I had to put the VFD on a separate earth to
the computer and machine.
Hope this helps.