|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Gecko 201X Adjust Screw
What is the function of the Adjust screw at the top of the drive? I searched the manual many times, and can't fine any reference.
|
#2
|
|||
|
|||
Manual only states this:
RESTORING FACTORY DEFAULTS To restore the G201X to the factory settings set the trimpot to the 11 o’clock position and set SW1-SW10 to “ON”. On other models like G540 the trimpot is used for midband resonance tuning. |
#3
|
|||
|
|||
This is from the 203V manual. I think it is for low speed tuning.
ADJUST: This trimpot adjusts the motor for the smoothest possible low-speed operation. Set the motor speed to about 1/2 revolution per second and then turn the trimpot until a distinct null is noted in the motor’s vibration. This will result in the most even microstep placement for a given motor and power supply voltage. The default setting for this trimpot is at ½ -turn and the setting for your motor will be within +/- ¼-turn of the default setting. |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3d Mold divot issue - SOLVED - Loose screw holding pinion gear | salewis | Troubleshooting | 41 | Tue 23 November 2010 11:36 |
Grinding flat spots on shaft for set screw seating | kanankeban | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 8 | Fri 02 July 2010 00:33 |
Gecko / Motor Tuning | sailfl | 701. Motor Drives | 9 | Tue 06 April 2010 12:13 |
Screw threads - inch & millimeter | Gerald D | Golden Resources | 1 | Mon 09 March 2009 00:54 |
gecko 210 | WOODCHUCKMAN | 701. Motor Drives | 3 | Sat 21 February 2009 13:13 |