|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#121
|
|||
|
|||
No, no filtration. This fan actually creates a breeze through the box, and blows out.
I used aluminum tubing, and a screen mesh, as my heat sinks. Filtration filter was a thought. I may add it later, if needed. |
#122
|
|||
|
|||
Does anyone cut 1 inch mdf or extira on a regular basis, with their machine?
|
#123
|
|||
|
|||
Figured it out. Was just cutting to fast, losing steps here and there. Experience can have it's cost. Wore out the bearing in my first spindle, two bearing. Spindle cut about 450 sheets of extira. Not bad for a 200 investment. Well worth it for the savings in broken bits using the porter cable setup.
|
#124
|
|||
|
|||
It's like a ghost town around here, in N. Ga.
|
#125
|
|||
|
|||
Out with the Old-----In with the new.
Well time has come, as planned. My little 4x4 build is growing. After cutting close to 8-900 sheets of 1-inch Extira and plywood, and lots of bits and mistakes... I took it apart this week. Going to build her back soon bigger. Learned a lot and gained a lot of knowledge, I didn't have before. It was still sad to take apart, after all the work I put in it.
|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ball Screw For Sale | Francois | The Market Place | 1 | Tue 07 February 2012 00:25 |
Ball screws | Richards | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 1 | Sun 28 August 2011 08:31 |
hobbed or ground rack? | southernduckie | Rails & Rollers | 11 | Thu 26 May 2011 09:36 |
Stepper motors giving trouble - Motors burnt while serving as ground for elec. fault | Daya | Troubleshooting | 45 | Mon 21 April 2008 02:05 |
Round shafts & ball slide blocks versus V-rails & V-wheels | joepardy | Rails & Rollers | 28 | Fri 07 December 2007 13:41 |