|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#31
Thu 30 August 2018, 04:59
|
|||
|
|||
|
quelques travaux ont été effectués meme si je n' ecris pas trop sur le forum.
Je ne peux y consacrer autant de temps que je veux et mon financement a été retardé ainsi j' avance doucement. D' abord j' ai fait les rails,j' attends les cremailléres pour les finir. 
|
|
#32
Thu 30 August 2018, 05:01
|
|||
|
|||
|
en anglais(désolé)
ome works have been done even if I do not write too much on the forum. I can not spend as much time as I want and my funding has been delayed so I'm moving slowly. First I made the rails, I wait for the racks to finish them.
|
|
#33
Thu 30 August 2018, 05:10
|
|||
|
|||
|
I also did the bevel on the Z plate
Photo1 the device without the plate photo 2 in situation j' ai aussi fait le biseau sur la plaque Z Photo1 le dispositif sans la plaque photo 2 en situation I made some soldering points to join the plate with the device stuck in the table J' ai fait quelques points de soudure pour solidariser la plaque avec le dispositif coincé dans la table etau
|
|
#34
Thu 30 August 2018, 05:16
|
|||
|
|||
|
j' ai aussi (mal )soudé le portique.
J' ai mal possitionné un embout et cela pose probléme pour le passage des cables. J' ai aussi commençé la peinture
|
|
#35
Fri 07 September 2018, 05:53
|
|||
|
|||
|
this week I welded the car there on my marble in marble: D
the adventure goes on. cette semaine j' ai soudé la voiture y sur mon marbre en marbre  l' aventure continue.
|
|
#36
Fri 14 September 2018, 08:31
|
|||
|
|||
|
It is nice table Eric. sembra fatto correttamente.
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New MechMate coming - Pacentro, Italy | Fablab SPQwoRk | Construction started, but not cutting yet | 12 | Wed 08 October 2014 15:11 |
| My Mechmate coming up - India | Manjeet Singh | Construction started, but not cutting yet | 13 | Sat 24 May 2014 23:49 |
| Table Coming Together! - QLD, Australia | BooY | Construction started, but not cutting yet | 37 | Fri 05 July 2013 19:34 |
| Donkeys being cut in France! - Galgan, France | bbreaker | MechMates already cutting | 71 | Sun 17 August 2008 21:58 |
| Cutting mdf doors, laser coming? #1 - Sri Lanka | fabrica | MechMates already cutting | 192 | Wed 23 January 2008 22:17 |
