#1
|
|||
|
|||
Putting table together
I finally had some time working on the table, while welding the side rail cross tube I forgot to leave enough room for the cross beam, Oh well I cut it out and reweld it tomorrow. I also installed some rubber casters for ease of moving around the garage. I can’t wait to get the table done so I can start working on the electronic parts.
|
#2
|
|||
|
|||
Dang, that foul between the cross-support channel and the diagonal brace also caught me originally. Hence this note on drawing 1010310W:
My original "fix" was to cut a piece out of the cross-support. That part of the cross-support does nothing for its strength. |
#3
|
|||
|
|||
If you cut angles on the ends of the cross rails, as indicated on the drawings, it may well avoid hitting that tube, try that first before cutting the welds loose.
|
#4
|
|||
|
|||
Your both right if I cut the cross beam at an angle there is plenty of room left without hitting the tube. I feel stupid now its a simpy fix why didn't I think of that.
THANKS |
#5
|
|||
|
|||
Cutting the end angle worked out great still had 1/4 inch gap left.
Kobus, I add and extra foot just in case I ever decide to add and indexer or tool changer later in the future but didn't realize the gap will be that big though. |
|
|