#1
|
|||
|
|||
c11 board video input mach3
Can someone tell me how to hook up video input into the c11 board so that mach3 can display the video feed
|
#2
|
|||
|
|||
Scotty,
I don't know the C11 board, but isn't video into mach3 not suppose to go through a USB connection on the PC? Ries |
#3
|
|||
|
|||
No video output on the C11 board. Your video monitor will be connected to the PC running the MACH3 software.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setting up a remote pushbutton as an input to Mach3 | Gerald_D | 70. Control Systems | 27 | Sat 22 March 2014 11:37 |
3D Elk cutting (video) #13 - Hagerman, New Mexico | Greg J | MechMates already cutting | 415 | Sat 05 September 2009 20:28 |
3d Elk in walnut with video! | Greg J | The Show Room | 13 | Mon 10 August 2009 06:50 |
What is the purpose of a spoil board or bleeder board? | j_wizard | 10. Base Table | 1 | Sun 09 August 2009 17:00 |
Alternative to Mach3 and Breakout Board using USB | dmoore | Miscellaneous / General / Whatever / Catchall | 0 | Thu 22 May 2008 12:59 |