#1
|
|||
|
|||
south coast.... of Australia
It's been a sloooow start but im getting momentum.
the beast will be 2750mm x 1850mm with aproxamatly 250mm z but i need repeatable accuracy of 0.01mm need some advice on this issue, looking for resolution of at least 0.005mm to ensure acuracy. mostly aluminium part manufacture and mdf pattern making for casting, one is tolerance specific the other is a rough it out job any help? Regards, Andrew |
#2
|
|||
|
|||
Andrew,
Did you read the other post's regarding your resolution request. Mr. Richards has put together a very good explaination of the expectations of the MM for your review. http://www.mechmate.com/forums/showt...&postcount=218 |
#3
|
|||
|
|||
hi sean,
Oh no i looked it was not there, so i decided to introduce myself again after several years dosen't look good though cheers andrew |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MM Quick Build #63 - Pretoria South Africa | Cois | MechMates already cutting | 71 | Sun 26 January 2014 11:30 |
Laser kits in South Africa | nicoferreira | Profiled (laser cut) & bent steel plate | 12 | Wed 08 February 2012 05:36 |
New Things - Pretoria, South Africa | Marinus | Introduce yourself and start planning | 11 | Tue 22 December 2009 00:50 |
Hi there Dave from South Africa | kooskoek | Introduce yourself and start planning | 14 | Mon 17 August 2009 09:09 |
South Africa's bright people . . . . . . | Gerald D | Archives | 14 | Wed 16 April 2008 15:41 |