![]() |
#1
|
|||
|
|||
![]() I've downloaded the plans and specs already, and have been "lurking" for a long time. I've connected with the good people here in the past, ie: Gerald, metalhead and a couple of others. Thanks by the way guys! After working as a construction PM for some time and after the market of retail being very soft the last few years, I am glad to say, I am back at it full bore and excited that I can now afford to start putting things together for my build this fall. I have a few ideas that vary slightly from the drawings, but I told Gerald I would not waver from the original design. On the first one anyway. Hopefully the veterans of MM will excuse my questioning and inquiring during process. Thank you Gerald for your contribution of not only the design but the forum to back up and support all of us that might have, and probably would struggle to manufacture and operate such a machine. Over the last year I have gone over and over the drawings and design trying to imprint them in my mind. I will be talking to all quite often and am looking foward to FINALLY getting this project underway. Thanks again G, and metalhead....I'll be talking to you soon.
![]() |
#2
|
|||
|
|||
Good Luck on the build Dan!
![]() |
#3
|
|||
|
|||
Welcome to the group Dan!
|
#4
|
|||
|
|||
Have fun with your build and PM me I have parts !!!
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Birthday serial number #26 - Round Rock, Texas | jhiggins7 | MechMates already cutting | 115 | Fri 30 August 2013 05:49 |
Rock Band Pedal | Roadkill_321 | The Show Room | 11 | Sun 21 February 2010 12:23 |
First time on this forum and just testing | Allan | Test Area for this forum | 9 | Thu 10 December 2009 00:12 |
Time to complete | devo | Archives | 15 | Thu 15 May 2008 20:56 |
Time To Start !! - Northeast Ohio | Marc Shlaes | Construction started, but not cutting yet | 8 | Mon 30 July 2007 12:10 |