#1
|
|||
|
|||
slow motion like animation
I just put a rhyming word out there
well here is the problem I have set steps per millimeter as 79.577 and the motors are driving crazily slow ! now if i set it to something like 250 steps per mm. which id offcourse wrong then its crazily fast. I know it should have been otherwise ? i don't even know what I am missing :??????? also the whole machine racks and jerks - may be bcos I have not yet tightened all the bolts - but that can be chkd later - hope some one can suggest what I am missing RGDS IRfan |
#2
|
|||
|
|||
Have you switched Mach from its default "inches" over to "mm"?
What is your belt ratio, pinion tooth count, and rack module/DP? |
#3
|
|||
|
|||
Config -> Select Native Units -> check MM
|
#4
|
|||
|
|||
Yes G' thats the exact thing I thought about - but I was in office since
will get back on this tomorrow morning : thank you - RGDS IRfan |
|
|