#1
|
|||
|
|||
CNC sandline cutting machine
Dear all:
Let`s introuduce a CNC sandline cutting machine to you. It widely used graphite epoxy boards, marble, jade, optical glass, ceramics, ferrite, the semiconductor material, silicon carbide, refractory bricks, which do not Conductive material part of its straight cutting the molding, such as graphite electrodes, and so on. If you want to know more detail for this machine,pls add my MSN MSN:delongcnc@hotmail.com MAIL: wj20020211@yahoo.com.cn |
#2
|
|||
|
|||
This post sounds a little fishy to me. No real contact info, no phone numbers etc, and all coming out of china?
Do you have any real contact info sir? |
#3
|
|||
|
|||
Hi, Heath:
Sorry for missing that. Our tel.is 86-523-86559889 And our website is :http://www.delong-cn.com/ MSN:delongcnc@hotmail.com MAIL: wj20020211@yahoo.com.cn Welcome to visit our site for knowing more detail! |
#4
|
|||
|
|||
Sorry for the skepticism, but we get a lot of spammers here, so its good to fish out the real businesspeople.
|
#5
|
|||
|
|||
I guess I'm a little puzzled about what that machine has to do with MechMate and the MechMate forum. Is it used to build MechMates? Is is used as an accessory to a MechMate? Is it related to anything required to owning a MechMate? Is it a machine that needs to be featured on the MechMate forum?
|
#6
|
|||
|
|||
I agree Mike, from the description it would be of little help in building a MechMate.
|
#7
|
|||
|
|||
Perhaps the alarm bells should ring when you see a hotmail adress for a company. Just a thought.
|
#8
|
|||
|
|||
Yeah thats what I thought initially also Kim.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Started my Cnc Machine (non-MechMate) Today - Stuart, FL | shelbygt500buddy | Construction started, but not cutting yet | 14 | Mon 06 July 2009 14:06 |
Is the MM the right machine for Me? (cutting thin boards and thick foam) | 1foamimprovement | General - MM Build | 5 | Wed 18 February 2009 18:24 |
Runs out of steam? Machine freezes during cutting - controlling PC's performance | liaoh75 | Troubleshooting | 11 | Thu 23 October 2008 22:34 |
Help me to choose a foam cutting CNC machine! | kotys2 | The Market Place | 3 | Wed 03 September 2008 17:33 |
Machine cuts out after cutting for a while - Loose wire on E-stop circuit | Hugo Carradini | Troubleshooting | 8 | Mon 31 March 2008 12:18 |