#1
|
|||
|
|||
Just Getting Started - Oran Algeria
Hi all
this is belmekki getting into it ''the mechmate''. I have been following almost all the discussions in this forum on the mechmate. And I finally got about one year ago "hit" by this machine construction. So far I started hardly to gather the pieces and it is not an easy job to do here in Algeria "Oran precisely". I will post regularly what I have reached in the construction soon. thanks Gerald for sharing this marvellous design with us third world countries. bye now |
#2
|
|||
|
|||
Weclome to the team !!
|
#3
|
|||
|
|||
Thank you Mike
Encouraging me will be very helpful |
#4
|
|||
|
|||
Welcome Ben!
|
#5
|
|||
|
|||
thanks Heath, soon some photos!
|
#6
|
|||
|
|||
welcome ben
|
#7
|
|||
|
|||
Hi all, here some photos of the mechmate. Started it about three weeks that's for assembly but for the cut pieces and all the rest of the stuff, it was a long run over a year.
On the second photo you may have noticed some bolts near the motor plate. This because of a misalignment in the plate welded on the spider. So these bolts will push the motor plate holder and align the pinion on the rack the result was good! Last edited by belmekki; Mon 14 February 2011 at 07:49.. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stickers on and cutting #77 - South Australia | Quadro | MechMates already cutting | 66 | Sat 29 September 2012 08:01 |
...started another MM, because I don't have one at home! | smreish | Construction started, but not cutting yet | 17 | Thu 30 December 2010 05:24 |
Just getting started.. couple questions... | Mountaincraft | 10. Base Table | 53 | Thu 02 September 2010 09:53 |
Getting Started - Karachi Pakistan | sohail | Introduce yourself and start planning | 29 | Fri 16 April 2010 07:47 |
Construction started - Greece | foinikas | Construction started, but not cutting yet | 20 | Thu 31 December 2009 10:13 |