|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Tue 25 November 2008, 17:41
|
|||
|
|||
|
Multiple routers/spindles/drills?
I saw this cool design on the web and was wondering if anyone has any designs for a multihead mechmate.
Robert http://www.camaster.com/cnc-routers/cobra-x3/ 
|
|
#2
Wed 03 December 2008, 14:30
|
|||
|
|||
|
Twin Router MechMate?
I tired a few searches to see if anyone had done a twin router MM yet and could not find anything. Have there been any that I missed?
|
|
#3
Wed 03 December 2008, 14:52
|
|||
|
|||
|
No one that I know of is running more than one tool head.
|
|
#4
Wed 03 December 2008, 19:48
|
|||
|
|||
|
You can fit two standard z-slides into the standard y-car. But then you need to find another route for the dust hose.
And two y-cars on a gantry is feasible. Multiple gantries on a table is also feasible.
|
|
#5
Fri 02 April 2010, 22:38
|
|||
|
|||
|
2 z slides on the same y car
Hi Gerald & forum,
I would be looking towards 2 heads, being an electronic's newbie, would the extra stepping motor (s) require an extra controler? as disscused above the 2nd z axis could slide into the the standard y carraige or an additional y carraige could be put on the gantry, my prefrence would be 1 y carriage. any thoughts on either option?
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
