#1
|
|||
|
|||
Basic laser part set for sale
Hello, I purchase a this set two years ago with the intentions of building a MechMate. Well life had other plans for me and they have just been sitting collecting dust, and it looks like I won't have any time soon to take on this project. So my lost is your gain.
This set is for sale for $300.00 shipping included in continental US only. You can contact me by email or phone (856) 236-1248 Items will ship from Philadelphia PA area 19154 Thank you, Tom Last edited by Rypper; Tue 13 July 2010 at 12:11.. Reason: time of purchase |
#2
|
|||
|
|||
Tommy,
May I note that the parts you have are for the MM classic, not the Mamba. It doesn't make that big of a difference, but the subtle changes in the parts of the newcomer are: - no cable chain attachment for gantry - no cable chain standoff for y car - "handed" y car end plates - "motor plate style" y car hold down - which means a fabricated hold down adapter plate is necessary. Some light modifications or fabrication will be necessary to accommodate current design intent. All these are not critical, just require attention to earlier forum post's in the 2005 to 2008 era. Good luck. Sean |
#3
|
|||
|
|||
Sean,
Thank you for the clarification, shows how long I have been away. I wasn't aware of the new model. Since this is the case I will open to any reasonable offer for these parts. Thank you, Tommy |
#4
|
|||
|
|||
Sent you a message through the forum mail.
|
#5
|
|||
|
|||
These parts are still available. I will accept any reasonable offer.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Basic Cutting Tutorial | Doug_Ford | General - MM Operating | 27 | Sat 20 August 2016 04:42 |
Laser Engraving on My Mechmate - the beginning - part 1 | fabrica | 50. Toolheads | 32 | Thu 09 June 2016 01:05 |
Basic theory of vacuum holddown & pumps | Gerald D | 10. Base Table | 2 | Mon 21 April 2008 05:00 |
How many laser profile cut components required per part number? | fabrica | Profiled (laser cut) & bent steel plate | 29 | Mon 07 January 2008 12:32 |
Finding a set of laser cut steel components to build the MechMate | Donald Neisler | Archives | 169 | Wed 03 October 2007 09:05 |