|
|
|||||||
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools |
|
#1
Wed 01 December 2010, 11:12
|
|||
|
|||
|
Planning for stepper driver
Now, I understand that most normal CNC require 34 size stepper motor. But at this time I want to use this stepper motor to make a small CNC machine yet. So I have found this circuit to drive this small stepper motor. Now I have 24V, 1.7 Amp power supply adopter and +5VDC logic supply from computer power supply. Now I want to ask that is it a good power supply to connect with this ULN2003 circuit? If not, then which is batter power supply?
|
|
#2
Wed 01 December 2010, 13:28
|
|||
|
|||
|
Same,
That motor will definitely not work for a Mechmate. Since this site is geared to the building of the Mechmate, you might find more relevant information over at CNC Zone. there are lots of small motor builds there. I would still suggest looking at Phils site, www.pminmo.com for DIY driver info.  |
|
#3
Wed 01 December 2010, 15:40
|
|||
|
|||
|
Well Said Heath !!!
|
|
| Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TIP142 Stepper motor driver | musicworld1 | 70. Control Systems | 19 | Tue 28 September 2010 21:23 |
| Stepper motor driver BOX for CNC router or plasma (just a box) | Albert0 | The Market Place | 0 | Thu 27 August 2009 19:14 |
| Would you mind to help me to solve the problem for Keling stepper Motor Driver? | qangel1000 | Motors & their mountings | 6 | Fri 07 August 2009 23:42 |
| http://ms-motor.com/ steppers, stepper driver, spindles, VFD | javeria | The Market Place | 4 | Sat 11 July 2009 23:53 |
| Keling Stepper, Servo Motor and Driver | Kelinginc | The Market Place | 0 | Wed 16 January 2008 13:55 |
