MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > After Building the Beast - Operating , Troubleshooting and Maintenance > Troubleshooting
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Thu 08 July 2021, 08:31
paul60
Just call me: woodguy
 
st george
Barbados
how to slave x motors

I have a shobot prt 96.
when i tried to run this morning it jump the rail found out x motors moving in
the same direction. need advise in resetting the slave . is there a step by step
instructions anywhere ?
If anyone can help thanks paul
Reply With Quote
  #2  
Old Fri 09 July 2021, 16:04
DocTanner
Just call me: Don Ross
 
Blue Ridge, Texas
United States of America
I believe Shopbot use their own software. Mechhmates typically use LinuxCNC or Mach.
I'm sure the guys over at http://www.talkshopbot.com/forum/forum.php will be able to help you.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Mach3 X axis with 2 motors set as slave viz 70. Control Systems 7 Sat 08 September 2012 08:58
Stepper motors giving trouble - Motors burnt while serving as ground for elec. fault Daya Troubleshooting 45 Mon 21 April 2008 01:05


All times are GMT -6. The time now is 12:02.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.